1) Clean surface thoroughly with rubbing alcohol.

2) Tape the graphic into position. (fig. A)

3) Measure & adjust location of the graphic.

4) When you have the graphic in the position
you desire, tape down the center of the graphic. (fig. B)

5) Tear tape (leaving half on the surface & other half on
application tape) & lift one side of the graphic and
separate the application tape from the backing paper.
Spray with solution of soap & water (approx. 1
tablespoon liquid dish soap in spray bottle full of
water). (fig. C)

6) Using scissors, cut away the backing paper. (fig. D)

7) Line-up tape on surface & on application tape. Squeegee outward from center. (fig. E)

8) Discard center strip of masking tape and lift
remaining side of graphic (tearing tape as in Step 5).
Remove backing paper, spray with solution and
repeat step 7. (fig. F & G)

9) Squeegee the entire graphic again pressing hard.

10) Allow time to dry.

11) Remove the application tape by pulling it back
over itself. (fig. H) Do Not pull application tape at a 90°
angle from surface (it can pull the graphics off with it).

12) Eliminate any air bubbles with a pin or exacto knife
and rub the air out with your finger or squeegee.